You can provide us with drawings, or we can draw simple drawings based on the data you provide. We will process the punching dies and they are mechanically punched to ensure the smoothness and spacing of the belts.
Conveyor punching is divided into two categories:
1. Through hole: completely penetrate from the back to the bottom of the belt.
2. Counterbore: There is a punch on the back or bottom of the belt, only one-sided recess, which does not penetrate the entire belt thickness.
Common functions of the punching belt:
1. Suction function: the hole is punched on the belt, and the product can be better sucked when the device is transported.
2, the installation of accessories: the hole on the belt and the through hole, the screw on the installation of the fixture, the bottom of the screw can be set inside the counterbore, so that the installation fixture can be achieved without affecting the belt.
3, drainage function: through the hole through the belt, the cleaning of the product to allow the water on the belt to flow away.
4. Precise positioning function: Accurate positioning hole on the belt along the horizontal or vertical direction can be used as a function of accurately transmitting or installing accessories.
5. Other functions used by the customer.
Punched ink green pvc conveyor belt
1, suitable for screening, suitable for filtration
2, strong pull, durable
3, suitable for fruit transportation and cleaning delivery, baffle 21
Conveyor belt processing style: 1. Add S-shaped skirt along the longitudinal direction of the conveyor belt to prevent the material from falling off from both sides of the conveyor belt during transportation. The height that can be added ranges from 10mm to 120mm, and can be customized according to customer requirements.
2. Add a T-shaped baffle along the conveyor belt to prevent the conveyor belt from slipping to the lower end during the climbing and lifting process. The T-shaped baffle acts as a barrier. The height can be increased from 10mm to 120mm, according to customer requirements.
3. Conveyor belt plus guide strip (the cross section of the guide strip is isosceles trapezoid. The bottom width * height is: (6 * 4 8 * 5 10 * 6 13 * 8) The processing of the guide strip can be the conveyance of the conveyor belt The lateral position of the surface can also make the longitudinal position, depending on the customer's use, and can also be added to the back of the conveyor belt, that is, the non-transport surface, to correct the deviation and position!
0.9mm (white or dark green, 1.3mm (white or dark green), 1.5mm (white or dark green), 2mm (white or dark green), 2.6mm (black) thickness PU oil resistant conveyor belt, 3.3mm dark green Pu steel plate conveyor belt 4mmpu steel plate conveyor belt (black, dark green