What Should I Do If The Rib Conveyor Belt Is Damaged?

- Aug 31, 2018-

1. The baseband edge (blank position) of the bezel conveyor is damaged.

If the edge of the conveyor belt is only slightly damaged and broken, it is necessary to observe whether the conveyor belt has a deviation during operation and whether it is damaged by external force. If the position of the empty side is torn, it is necessary to observe whether the pinch roller on the conveying line is a double pinch wheel. In principle, the belt is more than 500 mm and does not use a single pinch wheel. The function of the pressure wheel is mainly in the conveyor belt. The groove section prevents the conveyor belt from flying. If the base band is used, the single pinch pulley is used, and the force point is concentrated on the empty side of the base tape. If the thickness is thin, it will be easily torn and damaged. If the duplex type is used, During the operation, the inner wheel just presses on the top of the group edge, so that the force point is even, and there will be no tearing of the empty position.

18083007.jpg


2. The skirt and the partition of the baffle conveyor are torn off.

The site should observe whether the conveyor belt runs smoothly, whether the conveyor belt is derailed, whether it matches the effective bandwidth and the pressure pulley, whether the diameter of the drum meets the specified parameters, the running condition of the conveyor belt during the return stroke, and whether the baffle plate has ripples during the return stroke. The rigidity of the base tape itself. In the return stroke, if the baffle is wavy, it is easy to damage the baffle. If the baffle is hard, it can easily break from the bottom.

efdb6ff0f88f760ce029d6bae51c7a44_PVC-PU-Side-V-Guides-Conveyor-Belt-for-Good-Saftety.jpg

3. The base tape of the bulkhead conveyor belt breaks at the bottom.

It should be observed whether the diameter of the drum is small, the bending stress of the conveyor belt is too large, causing breakage, observing the non-working surface of the base belt, and seeing whether the base of the partition has obvious marks. If it is too obvious, the pressure of the secondary vulcanization partition is indicated. If it is too large, the conveyor belt will be damaged at this position, the canvas will be too large, and the rigidity will not cause breakage. Or there is no cleaning device on the conveyor line, causing hard objects to scratch and causing cross-cutting.314b5c7abae8e2a8859646ef085d0d42_PVC-PU-Side-V-Guides-Conveyor-Belt-for-Good-Saftety.jpg


3. The base tape of the bulkhead conveyor belt breaks at the bottom.

It should be observed whether the diameter of the drum is small, the bending stress of the conveyor belt is too large, causing breakage, observing the non-working surface of the base belt, and seeing whether the base of the partition has obvious marks. If it is too obvious, the pressure of the secondary vulcanization partition is indicated. If it is too large, the conveyor belt will be damaged at this position, the canvas will be too large, and the rigidity will not cause breakage. Or there is no cleaning device on the conveyor line, causing hard objects to scratch and causing cross-cutting.