Daily Inspection Of The Conveyor Belt

- Sep 22, 2018-

The inspection content is:

1 Whether there is abnormality in the conveyor belt and joint parts.

2 Transport with damage caused by cuts, cracks, penetrating injuries and other causes.

3 Whether there is interlayer peeling damage, especially at the joint.

Whether the 4 core has a broken part.

5 Whether the upper and lower covers are worn or not, especially the upper cover rubber, check whether the coal baffle contacts the surface of the conveyor belt.

6 Whether the conveyor belt has half wear.

7 Whether there are any wear on both sides of the conveyor belt.

360截图20160909091257643.jpg



201803201836374718110.jpg


2. Check the wear of the conveyor belt once a week. The inspection point should be a certain distance from the joint.

3. Check the operation once a week. The contents of the inspection are:

1 Whether the conveyor belt and the bracket are worn due to the deviation of the conveyor belt.

2 Whether the material has an eccentric load phenomenon.

3 Whether the conveyor belt sag between the rollers is normal.

4 Is there any phenomenon that the material on the conveyor belt overflows due to the excessive spacing of the rollers?

5 transport with no wrinkles and sagging phenomenon.

6 Whether the conveyor belt slips on the drive roller.

4, determine the elongation

Start the run and check if the tensioning device is working weekly. After one month, check it once a month. Check twice a year after three months of operation. During the inspection, the standard line distance set by the conveyor belt is measured by the tensioning device.

5, a visual inspection of the joint every week

Check for abnormalities such as trauma, bumps, etc. When inspecting, place the joint at a low tension.

6, check the loading point once a week

Check that the buffer roller position is correct and that the gap between the baffle plate and the conveyor belt is appropriate.

7. Check the cleaning device every two days.

Check that the scraper is working well and that the rollers and rollers are stuck with material.

8. Check the roller and roller every two days

360截图20160927112740419.jpg



201805181128081978420.jpg