Conveyor Belt Use Common Sense And Instructions

- Jul 05, 2019-

The conveyor belt will elongate during use. Some of them are elastically stretched, and can be restored to the original state after the external force is removed. The other part is the elongation of the shrinkage of the skeleton material. This part cannot be recovered.


       The running speed of the conveyor belt is generally not more than 2.5m/s. The material with large head and large wear and the unloading device using fixed pear should use low speed as much as possible.


       The relationship between the diameter of the drive roller of the roller conveyor and the layer of the conveyor belt, the matching of the drive roller, the reversing roller and the groove angle of the roller should be reasonably selected according to the design regulations of the conveyor.


       The feeding direction should be in the running direction of the conveyor belt. In order to reduce the impact on the conveyor belt when the material falls, the chute should be adopted to reduce the material drop distance; the conveyor belt receiving section should shorten the idler spacing and use the buffer roller as the leakage. The conveyor belt is compliant with a soft and moderate baffle plate to prevent the baffle plate from being too hard and scratching the belt surface of the conveyor belt.

Diamond belt

When the conveyor is in use, if there is no roller, it should be added and repaired in time; the roller is covered by the material, causing the rotation to be ineffective, preventing the leakage of the material between the roller and the tape, pay attention to the lubrication of the movable part of the conveyor belt, but not Oily conveyor belt.


       Avoid the belt being blocked by the frame, pillars or block materials to prevent breakage and tear. When the conveyor belt is partially damaged, the artificial cotton should be repaired in time to avoid expansion.


       Accurately specify the name and nature of the specific material. In particular, the particle size, temperature, and availability of corrosive and special requirements such as acid and alkali. The temperature to be used should be stated if necessary.


       Explain the specific application, the required specifications (width, length, number of layers, thickness, etc.), especially the temperature and volume of the heat-resistant conveyor belt.


       During transportation and storage, the conveyor belt should be kept clean and protected from direct sunlight or rain and snow to prevent contact with acids, alkalis, oils, organic solvents and other materials, and one meter away from the heating device.

Green diamond pattern conveyor belt