Conveyor Belt Jointer

- Mar 18, 2019-

Conveyor belt joint method

t01ac5ee40a29f2efbd

When you feel that it is not sticky and sticky, where there is a tape joint, the two rubber faces should be bonded from the middle to the sides to squeeze out the air. Knocking with a hand


Bond the surface and bond it. Then use a steel plate to compact and cure, the longer the better. Good aviation adhesive, after sticking


You can drive in 20 minutes, but it is better to put 3h.


t013c6405dc6d6ae45e


Comparison of several methods for conveyor belt bonding joints


        There are two types of conveyor belt bonding. Cold bonding and hot vulcanization bonding. The strength of these two joints can reach 80-90% of the conveyor belt; the mechanical joint strength is only 60-65%. And this


The type of connection does not leak the belt joint company, it is not easy to tear and not easy to hurt the drum. But these two methods also have their own advantages and disadvantages.

微信图片_20190311144945

Cold-adhesive: The advantage of bonding speed is short, the cost is low, and the position is better. Disadvantages are very demanding on the environment Steel ribbon joints, such as rain and snow, dust, adhesives are greatly affected by temperature. Durability is not as long as hot tack.

1dfa86bbdee036c8ffe5240c849ee93c_u=2390037158,736764296&fm=85&s=B8C3E3487BAAB76A4A50441F0300C0C2