Conveyor Belt Installation Tools

- Mar 19, 2019-

When we install stainless steel chain plates, they are generally installed according to the prescribed steps. In order to let everyone better understand the installation stage, the following is a brief list for everyone to refer to.


1. The installation of the rack frame for the transport equipment starts from the head rack, then installs the intermediate racks in sequence, and finally installs the tailstock. Before installing the rack, first pull the center line over the entire length of the conveyor. Since keeping the center line of the conveyor on the straight line is an important condition for the normal operation of the conveyor belt, it is necessary to install each section of the rack. Align the center line, and also set the shelf leveling. The tolerance of the frame to the center line is ±0.1mm per meter. However, the error on the center of the rack shall not exceed 35 mm over the entire length of the conveyor. Once all the blocks have been installed and aligned, the blocks can be connected.


CAM_1003-800x600

2. When installing the drive unit, when installing the drive unit, ou_cansh, care must be taken to make the drive shaft of the conveyor device perpendicular to the center line of the conveyor, so that the center of the width of the drive roller coincides with the center line of the conveyor. The axis of the reducer is parallel to the drive axis. . At the same time, all shafts and rollers should be leveled. The horizontal error of the shaft is allowed to be in the range of 0.5 to 1.5 mm depending on the width of the conveyor. At the same time as the driving device is installed, a tensioning device such as a tail wheel can be installed, and the drum axis of the tensioning device should be perpendicular to the center line of the conveying device.

timg (15)


3. After installing the roller, the rack and the transmission device and the tensioning device can be installed, the roller frame of the upper and lower rollers can be installed, so that the conveyor belt has a slowly changing arc, and the spacing of the roller frame of the bending segment is normal. The roller frame spacing is 1/2 to 1/3. After the roller is installed, it should be flexible and light.



4. The final alignment of the conveyor equipment is to ensure that the conveyor belt always runs on the center line of the rollers and rollers. When installing the rollers, racks and rollers,

uls2p55C3DMaFzS