Conveyor Belt Elongation Calculation

- Jan 11, 2019-

The relationship between the diameter of the transmission drum of the conveyor belt and the belt layer of the conveyor belt, the matching of the transmission drum, the reversing drum and the groove angle of the roller should be reasonably selected according to the design regulations of the conveyor.


The feeding direction should be in the running direction of the conveyor belt. In order to reduce the impact on the conveyor belt when the material falls, the chute should be adopted to reduce the material drop distance; the conveyor belt receiving section should shorten the idler spacing and use the buffer roller as the leakage. The conveyor belt is compliant with a soft and moderate baffle plate to prevent the baffle plate from being too hard and scraping the belt surface of the conveyor belt. The running speed of the conveyor belt is generally not more than 2.5m/s. The blockage is large, the materials with large wear and the unloading device using the fixed pear should be used at low speed.


When the conveyor is in use, if there is no roller, it should be added and repaired in time; the roller is covered by the material, causing the rotation to be ineffective, preventing the leakage of the material between the roller and the tape, pay attention to the lubrication of the movable part of the conveyor belt, but not Oily conveyor belt. Avoid the belt being blocked by the frame, pillars or block materials to prevent breakage and tearing. When the conveyor belt is partially damaged, the artificial cotton should be repaired in time to avoid expansion.