Is the conveyor belt selection difficult for you? Don't worry, there is XINBEX

- Jul 10, 2019-

Many technicians are guilty of the design and selection of the conveyor belt on the conveyor. Today, I will tell you what problems to consider when selecting the conveyor belt on the conveyor. It will not be so difficult to figure out these. First of all:


       1. Material conveyed by the conveyor belt:


       Under normal circumstances, it is necessary to consider the general characteristics, density, maximum particle size, etc. of the material; in special cases, it is also necessary to consider whether there is oil or chemical, the highest temperature of the hot material, the flame retardant demand, etc.;


       2. The maximum carrying capacity of the conveyor belt or the maximum conveying capacity required;


       3. Bandwidth;


       4, conveyor belt speed;


       5. Conveyor line layout:


       The distance between the head and the tail roller along the conveyor; the height of the lifting or lowering, or any elevation of the top and bottom of the conveyor section up or down; all the inclination of the conveyor section tilting up or down; all vertical The position and radius of the curve;

Green fishbone conveyor belt

6, conveyor belt drive:


      Single or double drum drive; if double drum drive, the total power of the motor is distributed on the first and second drive rollers; the wrap angle of the conveyor belt on the drive roller; the position of the drive; the surface of the drum, the smooth surface or the glue Face type; rubber surface type; starting form adopted;


      7, roller diameter:


      The diameter of the drum needs to be determined according to the actual requirements of the conveyor belt;


      8. Conveyor belt tensioning device:


      Type, position and tension stroke;


      9, roller:


      Type, roller diameter, groove angle; idler spacing, including the length of the transition between the head and the tail;


      10. Conveyor belt feeding device type:


      The number of chutes; the free fall height of the block to the conveyor belt; the length of the guide trough; the impact of the buffer roller or the buffer frame; the angle between the feeding and the belt;


      11. The minimum operating temperature expected when used in cold climates;


      12. Conveyor belt joint type adopted: vulcanized joint or mechanical joint;


      13. Conveyor belt cleaner type used: vulcanized or mechanical type.

Grey fishbone conveyor belt