How to replace the conveyor belt?

- Jun 17, 2019-

  1. Cut the old belt at the tail and punch the end of the old belt away from the outlet, and clamp the end of the belt with the splint;


Conveyor device


2. Cut the old belt again at the conveyor replacement outlet to form long and short sections of the old belt;



3. Set the tug at the belt replacement and connect the replacement tug to the conveyor bracket;



4. Passing the long section of the old belt from its end near the belt exit to the beginning through the pulley;



5. Use a sling to cover the beginning of the long section of the old belt, and then use the hook to lift the long section of the old belt upwards;



6. When the long section of the old belt is pulled to the stroke limit, place the long section of the belt that has been pulled away from the replacement outlet on the ground, then move the sling to the belt replacement exit and repeat step 5;



7. Measure the distance from the guide wheel to the endless belt change wheel, and cut the remaining unreplaced new conveyor belt according to the measured distance;



8. Connect the remaining new end of the belt to the end of the short section of the old belt away from the replacement outlet through the splint;



9. Passing the short section of the old belt from the end near its exit to the beginning of the belt through the belt tug;



Ten, use the sling to cover the beginning of the short section of the old belt, and then the hook will pull up the short section of the old belt;



11. When the short section of the old belt is pulled to the stroke limit, place the short section of the old belt that has been pulled away from the belt replacement outlet on the ground, then move the sling to the belt replacement outlet and repeat step 10;



12. When the old conveyor belt and the short section of the old belt are removed, the conveyor belt that needs to be updated will be connected, and the splint of the long section and the short section of the old belt will be removed, and the two ends of the new belt will be bonded. carry out;