In industrial production, the use of conveyor belts is very common, and the long-term use of conveyor belts will inevitably cause some damage or failure. Today XINBEX will explain how to effectively avoid these failures.
Avoid the use of conveyor belt failure elements:
1. XINBEX recommends that you first check the misalignment between the transverse centerline of the roller and the longitudinal centerline of the belt conveyor. If the non-coincidence value exceeds 3 mm, it should be adjusted with the long mounting holes on both sides of the roller set. The specific method is which side of the conveyor belt is biased, which side of the roller set moves forward in the direction in which the conveyor belt advances, or moves backward on the other side.
2. Secondly, XINBEX recommends that you should check the deviation of the two planes of the head and tail frame mounting housing. If the deviation between the two planes is greater than 1 mm, the two planes should be adjusted in the same plane. The adjustment method of the head roller is: if the conveyor belt runs away from the right side of the drum, the bearing seat on the right side of the drum should move forward or the left bearing seat moves backward; if the conveyor belt runs away from the left side of the drum, Then the bearing housing on the left side of the drum should move forward or the right bearing housing should move backward. The tail roller is adjusted in the opposite way to the head roller.
3. XINBEX recommends that you check the position of the material on the conveyor belt. The material is not centered on the cross section of the conveyor belt and will cause the conveyor belt to run off.